Floor levelling compounds wholesale online
Sakret BAM floor levelling compound (3–40 mm)
- Wear Class - A12
- Floor leveling before the final finishing
- Used as a final coating surfaces with little traffic
- Frost and moisture resistant
- Mechanically similar:
- Full and partial alignment of the horizontal plane, the slope of the creation of
- For concrete substrate defect repair
- Usable for heated floors
Sakret HDA levelling compound for wooden planks
Balancing mass for floors, fibre-reinforced - cement based mortar for interior use.
For creation of smooth, lip-free surfaces prior to laying of ceramic, natural stone and PVC coverings, carpeted floors on problematic substrates as for instance wooden floors, parquet, chipboards V 100 as well as all mineral substrates.
Sakret NSP low stress levelling filler
Hydraulically hardening, highly tempered, cementitious levelling filler.
For floor, for interior use.
For creation of surfaces ready to be covered with ceramic-, natural stone- and PVC coverings, carpeted floors, floating parquet and laminate.
Suitable for heating screeds.
Weber 4150 fine floor levelling compound
A pump applied floor screed formulated from special cements, aggregates, supplementary binders and chemical admixtures. It is supplied as a pre-blended dry powder designed for application at a thickness of between 4 - 30mm (Per normal concrete). The product is casein free.
Casco RenoRapid floor levelling compound
RENORAPID is a universal fast curing repair and leveling mixture. All kinds of surface irregularities, and smoothing. Fast drying product - you can walk on the surface after 45 minutes. For indoor and outdoor use. Can be used for wet and dry areas, as well as swimming pools, terraces and balconies. Universal repair mixture cement and polymers; floor, wall and ceiling leveling and repair. For use on wood, particle board and stone surfaces before ceramic tile or carpet laying and smoothing leveling compound for (screed) application. Consumption: 1.6 kg/m2 (1mm thick).
Knauf FE 50 self-levelling floor compound
Self-leveling floor Knauf FE 50 Largo factory-made, high-quality natural gypsum and anhydrite dry mortar mixture. Suitable for heated or "floating" floors, self-leveling. Intended for indoor use. The mechanical development. The minimum thickness of 25 mm. Knauf monolith flooring FE 50 Largo is the most economical and the most comprehensively-use self-leveling flooring range. This is consistent with the AE 20 categories and is well above the required compressive strength and bending strength. FE 50 Largo has proven itself for years, no matter whether it is an apartment building or a large area, continuous coating of offices; from the basement up to the roof. It can be used as flooring in the direct adhesion of floor coverings for the separating layer as a floating floor and even heating, only 35mm covering heating cables. Consumption: 1.9 kg/m2 (1mm thick).
Knauf Nivello self-levelling floor compound
Knauf Nivello is industrially produced gypsum and natural anhydrite (updated with special additives) mixture of self-leveling floor. For use as a self-smoothing the top layer. Intended for indoor use. Can be developed mechanically and by hand. The recommended thickness 8 - 35 mm. Consumption: 18kg/m2 (1cm thick). Packing: 25kg.